1999 Toyota Tacoma How To Change All Of The Serpentine belts

By | September 4, 2017


1999 Toyota Tacoma How to replace all of the serpentine belts.
It is best to start to remove all belts from the outside to the inside.

First start by loosening the tension on the fan belt bolt.
As seen in photo.




Then loosen up the fan pulley bolt.
After that you can remove the fan belt.
As seen in photo.

Next remove the AC compressor belt.
Start by loosing up the tension bolt.
As seen in photo.

After that is complete. Loosen the Ac compressor Pulley.
Then you can remove the Ac compressor belt.
As seen in photo.

The last belt that you need to be remove is the the alternator belt.
Loosen up the tension bolt as seen in photo.

Then loosen the alternator bolt. and remove the last belt.
As seen in photo.

After you have done all of these steps.
You can start to reinstall all of the belts.

First start by reinstalling the Alternator belt
Then adjust the tension bolt.
As seen in photo.

Then you will need to tighten the alternator pulley bolt.
As seen in photo.

After that is done . Install the Ac compressor belt.
Tighten up The compressor tension bolt.
As seen in photo.

Then tighten up the compressor pulley.
As seen in photo.

Now you can install the last belt the fan belt.
Tighten up the fan tension bolt.
As seen in photo.




The last step would be to tighten up the fan pulley.
As seen in photo.

Leave a Reply

Your email address will not be published. Required fields are marked *